Bertazzoni RWC60B4DNRP Instructions D’installation, D’utilisation Et D’entretien page 13

INSTALLATION INSTRUCTIONS
PREPARING FOR INSTALLATION
This appliance must not be installed close to heat
sources, e. g. heating elements or cookers, or in a
damp location.
Seek the help of one or two other individuals when
installing this appliance. This appliance may have
sharp edges. Wear PPE appropriate to the task and the
environment.
• Use the height-adjustable feet at the front of the
appliance to ensure that the appliance is level.
• The cooling system on the back of the appliance must
not touch the rear wall. The larger the gap, the better.
• The appliance must be installed with adequate
ventilation. Ensure that there is clearance above the
appliance to allow air to escape and that there is space
between the rear of the appliance and the wall.
• There must be no obstructions around the wine cooler or
in the built-in structure, and ventilation must be
maintained
Plug the appliance into an exclusive, easily accessible
electrical socket.
Any questions concerning
connection should be directed towards a qualified
electrician or an authorized products service center.
power and/or electrical
ELECTRICAL REQUIREMENTS
The appliance must be installed to all electrical connections
in accordance with state and local codes.
CAUTION
Do not use extension cords or two-prong
adapters and do not remove the ground
terminal of the grounding cable.
CAUTION
A qualified electrician must ensure that the
poles of the socket are connected correctly.
Verify that the grounding of the socket is
correct.
WARNING
Do not connect the appliance to electronic
energy saver plugs.
The socket must comply with the following data:
ELECTRICAL REQUIREMENTS
Plug type
Outlet
Voltage
Frequency
Fuse
After installation, wait at least 3 hours before connecting
the appliance to the electrical power to avoid damaging the
compressor.
IMPORTANT
Do not use extension cords and/or multiple
adapters for the power supply connection.
If the electrical wiring or the electric power supply of the
house requires alteration, the necessary procedures must
be performed by a qualified electrician.
Please heed the following rules:
• The electrical outlet or panel must be easily accessible
in case of an emergency; it must not be hidden behind
the product.
• The power supply connection should be easily
disconnectable after the appliance has been installed.
• Neither the plug nor the cable may touch the back
surface of the appliance. Otherwise, it may be damaged
by the appliance's vibrations.
• To prevent accidental injury, the cord should be secured
behind the appliance and not left exposed or dangling.
SCHUKO
2-prong
220 V – 240 V
50 Hz
10 A
13