Electrolux ESF5201LOW Notice D'utilisation page 17

Problem and alarm code
The appliance does not drain the
water.
• The end indicator flashes 2 times
intermittently.
• The Start indicator flashes con‐
tinuously.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• The Start indicator flashes con‐
tinuously.
The appliance stops and starts
more times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to
close.
Rattling/knocking sounds from in‐
side the appliance.
The appliance trips the circuit-beak‐
er.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
press Start. If the problem occurs again,
contact an Authorised Service Centre.
Possible cause and solution
• Make sure that the sink spigot is not clog‐
ged.
• Make sure that the drain hose has no kinks
or bends.
• Close the water tap and contact an Author‐
ised Service Centre.
• It is normal. It provides optimal cleaning re‐
sults and energy savings.
• If the delayed start option is set, cancel the
delay setting or wait for the end of the
countdown.
• The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• The appliance door is not centred on the
tub. Adjust the rear foot (if applicable).
• The appliance is not levelled. Loosen or
tighten the adjustable feet (if applicable).
• Parts of the tableware are protruding from
the baskets.
• The tableware is not properly arranged in
the baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate
freely.
• The amperage is insufficient to supply si‐
multaneously all the appliances in use.
Check the socket amperage and the capaci‐
ty of the meter or turn off one of the applian‐
ces in use.
• Internal electrical fault of the appliance.
Contact an Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
ENGLISH 17