Pollet Pool Group InverPro IP20 Manuel D'installation Et D'utilisation page 9

4.3 Self-priming
When switched on for the first time after installation, the pump will start self-priming automatically and followed
by self-learning.
Self-priming:
The system performs the self-priming in Boost mode, it will count down from 1500s and stop automatically when
the system detects the pump is full of water, then the system will recheck for 60s again to make sure the self-
priming is completed
Self-learning:
After the self-priming is completed, the system will perform the first time self-learning for 180s, and redefine the
flow range of the pump by detecting the pipeline pressure. eg: the default flow range of InverPro IP25 is 5-25
m³/h, after self-learning, the range may be redefined to 7-22 m³/h.
The default flow range for InverPro is as below:
Model
IP20
IP25
IP30
Remark:
The pump is delivered with self-priming enabled. Each time the pump restarts, it will perform self-priming
automatically. The user can enter the parameter setting to disable the default self-priming function.
If the default self-priming function is disabled, and the pump has not been used for a long time, the water level
in basket may drop, the user could manually activate the Boost mode of priming to fill it, the adjustable period is
from 600s to 1500s (default value is 600s).
The user could press
learning process after end the Boost mode.
4.4 Backwash
User can start the backwash or fast recirculation in any running state by pressing
Time
Running capacity
When backwash is completed or disable by pressing and holding
normal operating state before backwash.
Default flow rate range
5 ~ 20 m³/h
5 ~ 25 m³/h
5 ~ 30 m³/h
for more than 3 seconds to exit the Boost mode, The system will have a 180s self-
Default
180s
100%
Setting range
Press or to adjust from 0~900s with 30 seconds
for each step
80 ~ 100%, enter the parameter setting (zie 4.8)
for 3 seconds, the pump will return to the
.
9