Pollet Pool Group InverPro IP20 Manuel D'installation Et D'utilisation page 10

4.5 Manual-Inverter Mode
1
Unlock the screen, press
2
Press or to set the flow rate, each step by 1m³/h.
3
Press again to switch to Manual-Inverter mode.
4.6 Auto-Inverter Mode
Under Auto Inverter Mode, the pump could automatically detect the system pressure and adjust the speed of
motor to reach the set flow.
1
Hold for more than 3 seconds to unlock the screen
2
Press to start. The pump will run at a flow which is equivalent to 80% capacity after self-priming.
3
The flow rate could be adjusted, by pressing
The unit of flow rate could be changed to lpm, IMP gpm or US GPM, by pressing both
4
seconds.
5
Press to switch to Manual-inverter mode
Note: After the first self-priming, the pump will redefine the adjustable flow range. The system will record the
current pipeline pressure after running at the set flow/capacity for 2 minutes. During the pump running, if it is
detected that the pipeline pressure changes beyond a certain range, the icon of % or m³/h (or other flow unit)
symbol will flash for 5 minutes. If the change last for 5 minutes, the pump will restart the self-learning for 180s,
and redefine the flow range accordingly. After the redefinition of flow range, the pump will automatically adjust
the running capacity to reach the set flow.
10
to shift from the Manual-Inver mode to Auto-Inverter mode.
or with 1m /h for each step.
3
and for 3