Timer Mode; Parameter Setting - Pollet Pool Group Inverpro Ip20 Manuel D'installation Et D'utilisation

4.7 Timer mode

The pump's on/off and running capacity could be commanded by timer, which could be programmed daily as
needed.
1
Enter timer setting by pressing
2
Press or to set the current time.
3
Press to confirm and move to time-1 setting.
4
Press or to choose the desired running period and specific capacity or flow.
5 Repeat above steps to set other 3 timers.
6
Hold 3 seconds to save setting
7
or Check 4 timers to make sure there is no invalid setting
Note: Overlap setting of time will be considered as invalid, the pump will only run based on the previous
valid setting. During timer setting, if you want to return to the previous setting, hold both

4.8 Parameter Setting

Restore factory setting
Checking the version of software
Boost mode of self-priming
Enter parameter setting as below
Address Description
1 PIN3
2 PIN2
3 PIN1
4 Self-priming / Backwash capacity
5 Control mode of Analog Input
Enable or disable the priming that
6
occurs at each start
.
Under off mode, hold both
Under off mode, hold both
Under on mode, hold both
Under off mode, hold both
does no need to be adjusted, hold both
Default Setting
100%
80%
40%
100%
0
25
and for 3 seconds
and for 3 seconds
and for 3 seconds
and for 3 seconds; If current address
and to next address
Setting Range
30 ~ 100%, by 5% increments
30 ~ 100%, by 5% increments
30 ~ 100%, by 5% increments
80 ~ 100%, by 5% increments
0: Current control
1: Voltage control
25:enables
0: disables
& for 3 sec.
11