Injectors Replacement; Gas Selection - Aeg Hvb8453Ib Notice D'utilisation

pipes, be careful they do not come in touch
with mobile parts or they are not squeezed.
Also be careful when the hob is put together
with an oven.
Make sure that the gas supply pressure
of the appliance obeys the recommended
values.
If the supplied pressure has not the specified
value, it is necessary to assemble a proper
pressure regulator in compliance with the
standard UNI EN 88. For Liquid Gas (LPG)
the use of pressure regulator is allowed only
if they are in compliance with UNI EN 12864.
The adjustable connection is fixed to the
comprehensive ramp by means of a threaded
nut G 1/2". Screw the parts without force,
adjust the connection in the necessary
direction and tighten everything.
A. End of shaft with thread
Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end) (UNI-CIG
7129).
Flexible connection:
Use a flexible pipe in stainless steel (UNI-CIG
9891) with a maximum length 2 m.
WARNING!
When installation is complete, make sure
that the seal of each pipe fitting is
correct. Use a soapy solution, not a
flame!

3.3 Injectors replacement

WARNING!
Information for authorised installer only.
8 ENGLISH
1. Remove the pan supports.
2. Remove the caps and crowns of the
3. With a socket spanner 7 remove the
4. Assemble the parts, follow the same
5. Attach the label with the new type of gas
If the supply gas pressure is changeable or
different from the necessary pressure, you
must fit an applicable pressure adjuster on
the gas supply pipe.

3.4 Gas selection

Information for authorised installer only.
A 1. Deactivate the hob.
2. Press and hold
3. Within 7 seconds, press and hold the
4. Press the
5. To enter the gas selection mode press
Timer display shows selected gas type.
6. Press
7. To confirm the gas type press
Press
Automatic Switch Off function activates.
burner.
injectors and replace them with the ones
which are necessary for the type of gas
you use (see table in "Technical Data"
chapter).
procedure backwards.
supply near the gas supply pipe. You can
find this label in the package supplied
with the appliance.
WARNING!
for 3 seconds.
space below the three illuminated LEDs
next to the for 3 seconds.
symbol of the middle burner
until G1 appears on the display.
symbol of the middle burner.
to set the gas type according to
table below.
of the middle burner.
to exit the mode or wait for
symbol