Calibrating The Rpms; Activating The Bt Audio Source; Entering Pin Code For Bluetooth Wireless Connection - Pioneer DEH-P9800BT Mode D'emploi

Initial Settings

Calibrating the RPMs

Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer of this unit cannot work if you
do not perform the RPM calibration.
! In some vehicles, the tachometer may not
work properly even if you performed the
RPM calibration.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Use MULTI-CONTROL to select
Calibration.
Calibration appears in the display.
3 Keep RPMs of the engine at 4 000 rpm
and press MULTI-CONTROL.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4 000 rpm for a
few seconds.
When the RPM calibration is completed,
Completed is displayed.
# Some vehicles have a rev limiter that kicks in
early (e.g., 3 000 rpm) while parking. In this case,
perform RPM measurement at 2 000 rpm.
# To switch between 4000 rpm and 2000 rpm,
push MULTI-CONTROL left or right.

Activating the BT Audio source

You need to activate the BT Audio source in
order to use a Bluetooth audio player.
1 Use MULTI-CONTROL to select
BT AUDIO.
BT AUDIO appears in the display.
2 Press MULTI-CONTROL to turn the
BT Audio source on.
ON appears in the display.
# To turn the BT Audio source off, press
MULTI-CONTROL again.
Entering PIN code for
Bluetooth wireless connection
To connect your cellular phone to this unit via
Bluetooth wireless technology, you need to
enter PIN code on your phone to verify the
connection. The default code is 0000, but you
can change this in this function.
! With some Bluetooth audio players, you
may be required to enter to this unit in ad-
vance PIN code of your Bluetooth audio
player, in order to set this unit ready for a
connection from your Bluetooth audio
player.
1 Use MULTI-CONTROL to select
Pin code input.
Pin code input appears in the display.
2 Push MULTI-CONTROL up or down to
select a number.
Pushing MULTI-CONTROL up or down
changes the number.
3 Push MULTI-CONTROL right to move
the cursor to the next position.
When the number you want is displayed, push
MULTI-CONTROL right to move the cursor to
the next position and then select the next
number. Push MULTI-CONTROL left to move
backwards in the display.
4 After inputting PIN code (up to 16 di-
gits), press MULTI-CONTROL.
PIN code you entered is now standby to be
stored in memory.
Section
16
93
En