Graco MILESTONE LX ALL-IN-ONE CAR SEAT Manuel Du Propriétaire page 13

Turn Buckle Strap Sideways and
20
Slide to Desired Slot
Make sure buckle strap is in one
of the three positions.
21
Replace Seat Pad, Making Sure
the Buckle Goes Through the
Same Slot in the Seat Pad as in
the Plastic Shell
22
Pull All the Slack Out From
around the Waist
Pull up on the harness strap. Do
this to both sides.
23
Tighten the Harness by
Pulling the Harness
Adjustment Strap
When you are not able to pinch
any of the harness webbing
at your child's shoulder, the
harness is tight enough.
Booster Seat
24
Group 2 / 3 (15-36 kg)
Vehicle Lap/Shoulder Seat Belt
• Car seat must be forward-
facing in the vehicle seat.
A • Vehicle seat belts MUST lay
flat against child and MUST
NOT be twisted.
• Make sure vehicle seat's
shoulder belt is centered
between the child's neck and
edge of shoulder.
B • Never use a vehicle lap only
seat belt across front of child.
• DO NOT position vehicle
shoulder belt under the child's
arm or back.
• DO NOT allow child to slouch
or slide down in the booster
seat.
• DO NOT position vehicle seat
belt over top of armrests.
• If child will not keep the vehicle
seat belt properly positioned,
DO NOT use this booster seat.
Use a different car seat.
Booster Install
Store the Harness
25
Loosen the harness straps as
much as possible.
26
Raise the headrest to the
highest position.
27
Unbuckle the buckle.
28
Remove the Lower Seat Pad to
Expose the Harness
Storage Door ( , , )
A B C
29
Remove Buckle
A Recline the car seat and locate
the metal retainer.
B
Rotate the metal retainer up
through the shell and pad. From
the front, pull the crotch buckle
out.
30
Open the Harness Storage Door
and Place Harness, Buckle, and
Buckle Tongues Inside Storage
Compartment. Close the Door
31
Store Harness Covers
Place the harness covers in the
shell back openings as shown.
Replace Seat Pad
32
Move the headrest back to its
proper position for your child.
33
Recline the Car Seat
Place the booster seat in recline
position 4.
34
Place the Booster Seat
Forward-Facing in the Vehicle
Seat
Place forward-facing on a
vehicle seat that has a lap/
shoulder seat belt. The base
should sit as flat as possible on
the vehicle seat.
Securing Child In Booster
WARNING! Use only the vehicle
lap and shoulder belt system
when restraining the child in the
booster seat.
35
Place Child In Seat
Have your child sit in the
booster seat, with their back flat
against the back of the booster
seat.
36
Thread Vehicle's Shoulder Belt
Through Booster
Shoulder Belt Guide in the
Headrest
37
Buckle the Vehicle
Lap/Shoulder Seat Belt
Be sure the lap portion of the
vehicle seat belt goes behind
the armrests marked with a dark
red label.
Both the lap and shoulder belt
EN
must lay in the booster belt path
on the buckle side of the seat
marked with a dark red label.
38
Be sure the lap portion of the
vehicle seat belt is low across
your child's hips and is adjusted
snugly.
39
Vehicle seat's shoulder belt
should be centered between
the child's neck and edge of
shoulder.
Raise or lower the headrest
to change the shoulder belt
location on the child.
Accessories (on select
models)
40
Body Support
Body support must be used if
shoulders are below the lowest
harness setting.
Never allow body support to
bunch or fold behind child.
To remove, unbuckle the buckle
and pull out the body support.
41
For infants 0-5 kg, use the body
support wedge. Remove the
wedge for infants over 5 kg.
42
Headrest Pillow
To remove, pull out the pillow
out.
43
Cup Holder
Cup holder can be on either
side.
To attach, pull back the seat
pad to expose the attachment
13