Maintenance And Care; Changing The Propeller - Reely Cyclone Multi Notice D'emploi

14.

Maintenance and care

a) General
Clean the exterior of the model and the remote control with a soft, dry cloth or brush only. Never use abrasive cleaning
agents or chemical solutions, as these could damage the surfaces of the housings.
The cogwheels of the propeller drives must fit together securely without thereby being difficult to move in one place or
jamming. Propellers that are cracked or from which small pieces have broken off must be replaced in every case.
When replacing mechanical parts use only original spares available from the manufacturer.
The spare part list can be found on our website in the Download domain specific to the corresponding
product.
You can also order the replacement parts list by phone. For the contact data, please refer to the top of these
instructions in the chapter „Introduction".
b) Changing the propeller
The propellers (1) are each secured by a small screw (2)
that must be removed using a suitable screwdriver.
After you have pulled off the propeller upward, the pro-
peller shaft (3) with the main cogwheel (4) must be pu-
shed upward manually so that the unit does not slide
downward against the motor bearer.
Set the new propeller on the propeller shaft such that the
attachment screw catches in the screw opening (5) and
thus propeller and shaft are securely connected.
Important!
Do not use force or unsuitable tools and al-
ways pay attention to the rotational direction
of the propeller when you replace it.
66
Figure 22