Genesis GMSUDR15L Manuel D'utilisation page 15

WArning:
To avoid possible serious personal injury and possible kickback, never place the concave portion of bowed or warped
material against the fence.
MAinTEnAnCE
SAW BLADE INSTALLATION OR REMOVAL
WArning:
Be sure that the tool is switched off and unplugged from the power source before performing any
work on the tool.
WArning:
Use only 10" diameter saw blades that have 5/8" diameter arbor holes and are rated for speeds
equal to or greater then the nameplate rated rPM of this miter saw.
WArning:
Use only blades designed for cross-cutting operations.
WArning:
Do not use thin kerf blades with deep gullets which may deflect and contact the blade guards or
produce poor quality cuts in the work piece.
To remove the blade
1. Unplug the tool from the power source.
2. Unlock and move the saw arm fully upright.
3. Rotate the lower guard upwards to Blade Changing Position (See FIG 21). Blade locking bolt is exposed through the blade changing hole on the
lower guard.
4. Keep the lower guard in position with the palm of your right hand. Depress the rectangular spindle lock button below the carrying handle with your
index or middle finger, and rotate the blade until it is locked in place by the spindle lock.
(See FIG 22)
5. Maintain pressure on the spindle lock and keep the lower guard in the blade changing post ion with your right hand. Using your left hand and the
supplied Allen wrench, rotate the blade locking bolt clockwise to loosen. (See FIG 23).
6. Remove the blade locking bolt, small washer and outer blade flange washer.
7. Rotate the lower guard upwards as far as possible, then remove the blade from the motor spindle..
FIG 21
Blade Changing Position
To install the blade
1. Make sure the tool is unplugged from the power source.
2. Rotate the lower guard upwards as far as possible.
3. Mount the blade carefully onto the spindle, being sure that the directional arrow on the blade surface matches the arrow on the upper blade guard.
4. Install the outer flange and small flat washer.
5. Rotate the lower guard to blade changing position. (See FIG 21)
6. Install the blade changing bolt and turn it finger tight in a counterclockwise direction.
7. Depress and hold down the spindle lock while tightening the blade locking bolt securely with the provided wrench in a counterclockwise direction.
8. Release the lower guard to its original position.
9. Be sure the spindle lock has released and blade rotates freely before plugging in the tool and making a cut.
WArning:
Whenever installing a new blade, always be sure that the new blade does not contact any part of the
machine's metal base when the handle is completely lowered. Perform this test with the tool unplugged from the power
source.
FIG 22 FIG 23
15