Door Reversal (Optional) - Maytag W11183136B Instructions Pour L'installation

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round and
square-shaped doors.
T ools needed:
Min. 8" (203 mm) long
TORX , T20 and
® ® ,
T25 ® screwdrivers
†
REVERSE DOOR SWING: ROUND-SHAPED DOOR
DOORS WITH ELECTRICAL WIRING:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.
Disconnect wiring from door
Using a Phillips screwdriver , remove middle screw in hinge.
Disconnect wiring. T uck wiring into opening.
† ® TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.
24
#2 Phillips screwdriver
ALL DOORS:
2.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed from
the dryer , peel the film from the dryer door before proceeding.
Using a T25 screwdriver , remove the four screws securing the
®
door hinge to the dryer and lift the door up and out to remove.
Place the door on a soft towel or other non-scratch surface.
3.
Move the door strike
Using a T25 screwdriver , remove the two screws securing the
®
door strike to the door frame of the dryer . Rotate the strike 180°
and attach to the opposite side of dryer door frame with the two
screws removed earlier , as shown.