Sony BDV-L600 Mode D'emploi page 68

Sound
Symptom
There is no sound or wireless
transmission is not activated.
The Super Audio CD sound of a
component that is connected to
the HDMI IN 1 or HDMI IN 2
jack is not output.
There is no sound from the TV
via the HDMI OUT jack when
using the Audio Return Channel
function.
The system does not output
sound correctly when connected
to a set-top box.
Severe hum or noise is heard.
The sound loses stereo effect
when you play a CD.
The left and right sounds are
unbalanced or reversed.
68
US
Problems and solutions
• The speaker cord is not connected securely.
• Check that the AC power cord (mains lead) of the subwoofer is connected
securely.
• Check that the volume of the main unit is other than "0."
• Check the status of the LINK/STANDBY indicator on the subwoofer.
– Turns off.
– Check that the AC power cord (mains lead) of the subwoofer is connected
securely.
– Turn the subwoofer on by pressing "/1 on the subwoofer.
– Flashes green quickly.
– 1 Press "/1 on the subwoofer. 2 Insert the wireless transceiver into the
subwoofer correctly. 3 Press "/1 on the subwoofer.
– Flashes red.
– Press "/1 to turn off the subwoofer, and check the following items.
1Are the + and – speaker cords short-circuited?
2Is anything blocking the ventilation openings of the subwoofer?
After checking the above items and fixing any problems, turn on the
subwoofer. If the cause of the problem cannot be found even after
checking all the above items, consult your nearest Sony dealer.
– Flashes green or orange slowly or turns red.
– Make sure that the wireless transceiver is inserted correctly into the main
unit.
– Make the [Secure Link] setting again (page 52).
– Sound transmission is poor. Move the subwoofer so that the LINK/
STANDBY indicator turns green or orange.
– Move the system away from other wireless devices.
– Avoid using any other wireless devices.
– Turns green or orange.
– Check the speaker connections.
• HDMI IN 1 and HDMI IN 2 does not accept an audio format that contains copy
protection.
• Set [Control for HDMI] in [HDMI Settings] of [System Settings] to [On]
(page 62). Also, set [Audio Return Channel] in [HDMI Settings] of [System
Settings] to [Auto] (page 62).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that a High Speed HDMI cable is connected to a jack on your TV
that is compatible with the Audio Return Channel function.
• Set [Audio Return Channel] in [HDMI Settings] of [System Settings] to [Off]
(page 62).
• Move your TV away from the audio components.
• Clean the disc.
• Select stereo sound by pressing AUDIO (page 42).
• Check that the speakers and components are connected correctly and securely.