[Network Settings]; [Easy Setup]; [Resetting] - Sony BDV-L600 Mode D'emploi

[Network Settings]

You can make detailed settings for Internet and
network.
x [Internet Settings]
Connect the system to the network beforehand.
For details, see "Connecting to the network"
(page 21).
x [Network Connection Diagnostics]
You can run the network diagnostic to check if
the network connection has been made properly.
x [Connection Server Settings]
Sets whether or not to display the connected
DLNA server.
x [Renderer Options]
[Auto Access Permission]: Sets whether or not
to allow automatic access from newly detected
DLNA controller.
[Smart Select]: Allows a Sony DLNA controller
to find the system as the target component to
operate by using the infrared ray. You can set
this function to on or off.
[Renderer Name]: Displays the system's name
as it is listed on other DLNA devices on the
network.
x [Renderer Access Control]
Sets whether or not to accept commands from
DLNA controllers.
x [Party Auto Start]
[On]: Starts a PARTY or joins an existing
PARTY at the request of a networked device
compatible with the PARTY STREAMING
function.
[Off]: Off.
x [Media Remote Device Registration]
Registers your "Media remote" device.
x [Registered Media Remote Devices]
Displays a list of your registered "Media
remote" devices.

[Easy Setup]

Re-runs the Easy Setup to make the basic
settings. Follow the on-screen instructions.

[Resetting]

x [Reset to Factory Default Settings]
You can reset the system settings to the factory
default by selecting the group of settings. All the
settings within the group will be reset.
x [Initialize Personal Information]
You can erase your personal information stored
in the system.
63
US