Progress Lighting 5238 Instructions De Montage Et D'installation

ROCRESS
LIGHTING
WARNING:- This lighting fixture ISdesigned for use With maximum 25A, 15V power units only
Do not exceed wattage rating noted on power supply!
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or
other reproductive harm. Thoroughly wash hands after Installing, handling, cleaning, or otherwise touching this product.
CONNECTIONTO PROGRESS8590/91/92/93/94/95/96
CAUTION: Do not touch bulb with bare hands Oil from skin may damage the bulb. Using a soft dry cloth or cotton gloves,
clean the halogen bulb With rubbing alcohol. Halogen bulbs operate at extremely high temperatures and pressures
they will shatter if not handled correctly.
10
Figure 1
Assembly & Installation
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation
5238
11
PAGE
REMOTETRANSFORMERS
1 Slip Fixture Wires (2) through Stem (3) and down through top opening of
Ground Stake (1). (Fg 1)
2.- Thread one end of Stem (3) into Ground Stake (1) Thread the other end
of the Stem (3) into the Cast Aluminum
3 - Connect Fixture Wires (2) to Supply Wires using Wire Connector
as shown •n Fig 1
4.- Remove Screws (5) and lift Cast Aluminum
(8) from Cast Aluminum Lens Retaining
5 - Install Lamp (7) into BI-Pln Socket (6)
6. Carefully place Glass Panel (8) over Lamp (7) and onto Cast Aluminum
Lens Retaining Plate (4). Place Cast Aluminum
(8) and secure In place with screws (5) (DO NOT OVERTIGHTEN)
CAUTION: All glass s fragile, use care when handling Glass Panel (8) and
Lamp (7).
7 - Insert Ground Stake (1) into Ground
8 - Connect Fixture Wire (12) to selected
Wire Connector (10) provided with fixture. (Fig. 2)
9 - Press 10 Ga cable Into slot marked
marked 12 Ga Lay the 18 Ga. Wire into slot marked 18 Ga.
Caution. Wires must lay flat in the slot.
10.- Assemble the Wire Connector (10) by aligning the Tab (14) of the
contact half of the connector with the Notch (15) in the wired half of the
connector (Fig. 2)
11 .- Compress the two halves by securely tightening the Thread Cutting
Screw (16), forcing the contacts Into the wires
Note: Do not install luminaire within 5 feet of a pool, spa, or fountan
10
14
15
12
FIG.
1 of 4
Instructions
Socket Holder (11)
(10 )
Cover (9) and Glass Plate
Plate (4)
Cover (9) over Glass Plate
10 or 12 Qa. Cable (13) wth the
10 Ga. Press 12 Ga. cable into slot
(Fig 2)
16
fi*ture
| cable
13
2
SPEC NO 023135 04/16/09