Progress Lighting 5250 Instructions D'assemblage

OGRESS
LIGHTING
WARNING - THIS LIGHTING
DO NOT EXCEED WATTAGE
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and lor
other reproductive harm. Thoroughly wash hands after Installing, handling, cleaning, or otherwise touching this product.
CONNECTION
15
OPTIONAL PROGRESS
8618 GROUND STAKE
Assembly
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation
FIXTURE IS FOR USE WITH MAXIMUM
RATING NOTED ON POWER
TO PROGRESS 8590/91/92/93/94/95/96
1 - Slip Fixture Wires (1) down through
2. Thread Stem (3) firmly down Into Progress 8618 Ground Stake (5). Slip Fixture Wires (1) out
through open Side of stake and make connections
shown (Fig. 1). Push stake down Into ground until top of stake IS even with grade (Fig. 1)
3. Install lamp (15) 12 volt, 18 watt wedge base (T-5, #921
4. Lift Glass Cage Assembly
holes •n Roof (9). Secure Glass Cage Assembly
(DO NOT OVERTIGHTEN)
CAUTION
5.- Connect Fixture Wire (10) to selected 10 or 12 Ga. Cable (11) with the Wire Connector
Assembly
6. Press 10 Ga. cable Into slot marked 10 Ga. Press 12 Ga. cable into slot marked 12 Ga Lay
the 18 Ga. Wre Into slot marked 18 Ga. (Fig. 2) Caution
7 - Assemble the Wire Connector (4) by aligning the Tab (12) of the contact half of the connector
With the Notch (13) •n the wred half of the connector. (Fg
8. Compress the two halves by securely tightening the Thread Cutting Screw (14), forcing the
contacts Into the w•res. (Fig. 2)
Note. Do not Install luminaire within 5 feet of a pool, spa, or fountan
5
FIG 1
& Installation
5250
25A, 15V POWER
SUPPLY!
REMOTE TRANSFORMERS
Nipple (2) and thread Nipple into Stem (3)
(6) up into Roof (7) of fixture assembly and slip Studs (8) through
• All glass ISfragile, use care when handling Lamp and Glass Cage Assembly (6)
(4) provided wth fixture
10
PAGE 1 of 4
Instructions
UNITS ONLY.
to supply wres using W re Connector
(6) by threading two Ballnuts (9) onto Studs (8)
Wires must lay flat •n the slot.
2)
14
12
fi*ture
13
d caDle
TO
11
FIG 2
SPEC NO 023098
(4) as
04-21-09