Progress Lighting 5262 Instructions De Montage Et D'installation

'+PRPC RESS
LIGHTING
WARNING:-
WIRING:- Run #12 Ga. Cable (Cat. No. 8628 or 8699) from selected transformer to predetermined fixture locations
Connect #18 Ga. Jumper Wres (NOT FURNISHED) to 12 Ga. Wire with Progress 8673 Connectors. (See schematic on page 4).
Connect #18 Ga Jumper Wires to Fixture Wires with UL Listed Wirenuts. (NOT FURNISHED)
WARNING 1 - This product contains
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
11
9
8
10
6
5
2
1
3
Assembly
CAUTION: Read instructions
circuit breaker panel before beginning installation.
This lighting fixture is designed for use with maxmum 25A, 15V power units only.
Do not exceed wattage rating noted on power supply!
chemcals known to the State of California
19
7
4
12
FIG
& Installation
carefully and turn electricity off at main
5262
to cause cancer, birth defects and lor other
Mounting Post Light to Standard
1.. Pull #18 Ga. Jumper W,res (1) (NOT FURNISHED),
Ga. Jumper Wires (1) through Mounting Cap (2) and place Mounting Cap (2) over 4 x 4
Post (3)
2.- Cut Fixture Wires (4) to fit Inside Splice Box (5) and strip wres 1/2 Inch
3.- Connect Fixture Wires (4) to #18 Ga. Jumper Wires (1) as shown on wring diagram
4.- Place Splice Box (5), With Fixture Assembly (6), over Mounting Cap (2) and secure •n
place with four Screws (7). W re connections,
FURNISHED), to be secured inside Splice Box (5)
5.- Install lamp (19) 12 volt, 18 watt wedge base (T-5, #921)
CAUTION. ALL GLASS IS FRAGILE,
6.- Place Cage Assembly (8) and Roof (9) over Nipple (10) and secure •n place with Knob
(11). (FINGER TIGHTEN ONLY)
7.- Connect Fixture Wire (13) to selected 10 or 12 Ga Cable (14) wth the Wire
Connector Assembly (18) provided with fixture
8.- Press 10 Ga. cable Into slot marked
Ga. Lay the 18 Ga. Wire into slot marked 18 Ga. (Fig. 2)
Caution. Wires must lay flat in the slot.
9.. Assemble the Wire Connector (18) by aligning the Tab (15) of the contact half of the
connector wth the Notch (16) n the wred half of the connector. (Fig. 2)
10.- Compress the two halves by securely t.ghten.ng the Thread Cutt.ng Screw (17),
forcing the contacts Into the wres. (Fig. 2)
Note. Do not install luminare within 5 feet of a pool, spa, or fountain
Mountinq Post Light to Plastic 4 x 4 Post
Two 1/8" holes to be pre-drilled in the Sides of the Mounting Cap (2) as shown and
secured in place With two Screws (12).
Mountinq Post Light to Top Railing
Do not use Mounting Cap (2) when mounting Post Light to Top Rall ng
18
18
15
13
PAGE 1 of 4
Instructions
4 x 4 Post
through 4x4 Post (3). Slip #18
With UL Listed Wirenuts (NOT
USE CARE WHEN HANDLING LAMP
10 Ga. Press 12 Ga cable into sot marked
fixture
16
TO
FIG 2
SPEC.NO.
12
coble
022051 02-11-09