Progress Lighting 5200 Instructions De Montage Et D'installation

ROCRESS
LIGHTING
WARNING. THIS LIGHTING
DO NOT EXCEED
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and lor
other reproductive harm
1.- Slip Fixture Wres (1) into Ground Stake (3). Thread Adapter (2) firmly down Into Ground Stake (3) and make connections
shown •n (Fg 1). Push stake down Into ground until top of stake is even with grade
CAUTION: All glass ISfragile, use care when handling Glass Lens (7) and lamp
2 - To replace lamp, remove Screws (5), Faceplate (6) and Glass Lens (7)
3 - Connect Fixture Wire (8) to selected 10 or 12 Ga Cable (9) with the Wire Connector Assembly (4) provided wth fixture
4.- Press 10 Ga. cable into slot marked 10 Ga. Press 12 Ga. cable into slot marked 12 Ga
Caution Wires must lay flat In the slot.
5 - Assemble the Wire Connector (4) by align ng the Tab (9) of the contact half of the connector wth the Notch (11) n the wired half of the connector
6 - Compress the two halves by securely tightening the Thread Cutting Screw (12), forcing the contacts Into the w•res. (Fg
Note. Do not Install lumnare within 5 feet of a pool, spa, or fountain
Assembly
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation
FIXTURE IS FOR USE WITH MAXIMUM
WATTAGE RATING
Thoroughly wash hands after Installing, handling, cleaning, or otherwise touching this product.
FIG 1
& Installation
5200
25A, 15V POWER UNITS ONLY
NOTED ON POWER SUPPLY!
Lay the 18 Ga. Wre •nto slot marked 18 Ga. (Fig. 2)
PAGE 1 of 4
Instructions
12
10
fixture
11
FIG 2
to supply wres using Wire Connector
(Fig 2)
2)
SPEC NO 022520
12\/ cable
(4) as
(01-05-09)