Safety Provisions; Extra Information - Inventum Ika6035 Manuel D'utilisation

Attention:
Longlife carbon filters should be replaced every five years.
Attention:
A plasma filter is not included. You need to order it.

SAFETY PROVISIONS

Pan detection mode
With the pan detection mode, the appliance does not work if you use an unsuitable pan or if the appliance does not detect a
pan on a cooking zone. The operation indicator shows U and it is not possible to increase the power level.
Residual heat indicator
After stopping the appliance, the cooking zones stay hot. If you touch a hot cooking zone this may result in injury. The
operation indicator shows H/h to indicate the cooking zone is hot. When the cooking zone is cool, the operation indicator no
longer shows H/h.
3

extra information

REQUIREMENTS FOR PANS (Figure 3)
Note:
Pans that were previously used on a different appliance (for example a gas appliance) are no longer suitable for an
induction appliance.
3
• Use pans with a thick and flat bottom. The diameter of the pan must be the same as the diameter of the cooking zone.
• Use pans made from metal, enamelled metal, cast iron or stainless steel. These pans give the best result.
• Obey the instructions from the manufacturer of the pan to see if the pan is suitable for an induction appliance.
• Pans made from metal or aluminium pans with a copper bottom may stain the glass plate. Remove the possible stains
immediately after using the appliance.
• Use a magnet to check if a pan is suitable for an induction appliance. The pan is suitable if the magnet sticks to the
bottom of the pan.
• Make sure that you put the pan in the center of the cooking zone.
• Some pans may produce sounds during use. The sounds are caused by the shape of the pan. This does not affect the
operation or safety of the appliance.
• Never slide pans over the appliance, always lift the pans to avoid scratching the glass.
POSSIBLE SYMBOLS ON THE DISPLAY
Indication on the display
U
H/h
II
Lo
--
EF
88
26
• English
Usage
Error message. Place a suitable pan on the active cooking zone or switch off the cooking zone.
Something has been placed on the control, or the cookware is unsuitable or too small.
Residual heat indicator: the cooking zone is still too warm to touch.
Pause indicator: the cooking zones are heated at the lowest setting.
The child lock is activated.
The induction hob is standby.
A breakdown has occured. Check the indication, refer to section Breakdown codes.
The set power of the cooking zone or timer.