Inserting/Replacing The Screw Bit; Using The Twist-Grip; Switching On And Off/Screwing - Batavia DUO BT-CSD002 Mode D'emploi

charged after only 60 seconds. This way it is
ready for use all the time.
Regardless of the charging condition, the
flash cell screwdriver can be charged at any
time without damaging the cells.
Charge the screwdriver before first use.
Note:
The charger BT-FCC001 can only be used for
the driver BT-CSD002.
1. Connect the power cord (5) of the charger
(6) with a wall socket. The first LED of the
charging LEDs (3) lights up.
2. Put the lower end of the handle of the
screwdriver, as pictured on the overview
photo, as far as it will go into the charger, by
inserting the charging terminals into the
corresponding openings of the charger.
3. Depending on the charging state, the
corresponding charging LEDs light up and
flash. The flash cell is fully charged when all
LEDs shine permanently. The screwdriver is
ready for use.
Note:
When inserting the screwdriver into the
charger, make sure it easily can be placed. Do
not use force.

INSERTING/REPLACING THE SCREW BIT

• Before changing the screw bit, set the
rotating direction button (7) into the middle
position to avoid unintentional start-up.
• Only replace the screw bit when the
screwdriver is switched off.
7061166 Ma # 1201-09.indd 15
• Pull out the screw bit from the bit holder (1)
and replace it with the desired one. A
magnet inside the bit holder holds the
screw bit in its place.

USING THE TWIST-GRIP

The flash cell screwdriver is equipped with an
adjustable twist-grip which can be setup as a
straight grip or as a pistol grip. Press the
unlocking button (8) at the top of the screw-
driver and twist the grip to the desired position.
Straight Grip

SWITCHING ON AND OFF/SCREWING

1. Press the ON/OFF trigger (2) to switch
on the flash cell screwdriver. Release the
trigger to switch off the screwdriver.
2. Use the rotating direction button (7) to
reverse the rotating direction. In the
middle position the ON/OFF trigger is
locked. Set the switch to this position
when putting down the machine to avoid
an accidental start-up.
3. Before using the machine, check whether
the screw bit is inserted correctly. Avoid
overtightening as this may damage the
screw head or the threads. Press the
screw bit against the screw with a
constant pressure and drive in the screw.
EN
Pistol Grip
15
09-01-12 12:29