Light Attachment; Cleaning And Storing; Technical Data - Batavia DUO BT-CSD002 Mode D'emploi

4. To unscrew, setup a counter clockwise
rotating direction. Insert the screw bit into
the slot in the head of the screw. Hold the
screw-bit straight to the head of the
screw to avoid damaging the screw or
the screw head. Use a constant pressure
when pressing the screw bit against the
screw while removing the screw.
5. After screwing, always put the flash cell
screwdriver into the charger. This way it
will be ready for use all the time.
Note:
The rotating direction button can only be
pressed, while the ON/OFF trigger is
released.

LIGHT ATTACHMENT

1. Remove the screwdriver from the charger.
2. Put the light attachment (9) from below
on the grip of the flash cell screwdriver.
Make sure is audibly snaps in.
3. Press the ON/OFF switch (12) at the light
attachment to switch on the LED torch
(11).
4. Press the ON/OFF switch (12) again to
switch off the LED torch and to switch on
the LED work light (10).
5. Press the ON/OFF switch (12) a third
time to switch off both LED lights.
6. Pull off the light attachment straight from
the grip of the screwdriver in order to
remove it.
Note:
The flash cell screwdriver can only be
charged when the light attachment has been
removed.

CLEANING AND STORING

• Unplug the charger before cleaning it.
• Use only a dry or lightly moist cloth to
clean the unit. Do not use aggressive
chemicals as benzene or thinner, which
may dissolve plastic parts, or abrasives.
16
7061166 Ma # 1201-09.indd 16
TM
• Store the unit at a dry location that is
protected from dust, dirt and extreme
temperatures. Store it out of reach of
children.

TECHNICAL DATA

Charger
Rated Input Voltage
Rated Output Voltage
Rated Power Input
Rated Power Output
Charging Time
Protection Class
Weight
Dimensions (Approx.)
Flash Cell Screwdriver
Input
Conductor
Max. Torque
No Load Speed n
0
Sound Pressure Level
Uncertainty
Sound Power Level
Uncertainty
Vibrations a
h
Uncertainty
Weight
Dimensions (Approx.)
Light Attachment
LEDs
Weight
Dimensions (Approx.)
The following information:
• that the declared vibration total value has
been measured in accordance with a
standard test method and may be used for
comparing one tool with another;
• that the declared vibration total value may
also be used in a preliminary assessment
of exposure.
230-240 VAC
4.6 VDC
40 W
2.4 A
ca. 60 s
II
592 g
54 x 71 x 77 mm
4.6 VDC
2.3 VDC, 300F
(2 pcs)
2.5 Nm
200 min
-1
L =58.7 dB(A)
pA
K =3 dB(A)
pA
L =69.7 dB(A)
WA
K =3 dB(A)
WA
HD=0.295 m/s
2
K=1.5 m/s
2
366 g
53 x 185 x 145 mm
5x /
1x LED white
62 g
54 x 71 x 77 mm
09-01-12 12:29