DeWalt DW325C Guide D'utilisation page 7

WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• c rystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Specifications
MODEL
HEIGHT
WIDTH
LENGTH
WEIGHT
OPERATING PRESSURE
AIR CONSUMPTION PER 100
CYCLES *
LOADING CAPACITY
FASTENER LENGTHS
SHANK DIAMETER
FASTENER COLLATION
*Take the actual rate at which the tool will be run to determine the
amount of air required. For instance, if your fastener usage averages
50 nails per minute, you need 50% of the 7.8 c.f.m. which is
required for running at 100 nails per minute.
COMPONENTS (FIG. 1)
A. Trigger
B. Exhaust deflector
C. No-Mar pad
5
DW325C
13-1/4" (336 mm)
5-9/16" (140 mm)
12-1/16" (306 mm)
8 lbs 8 oz (3.86 kg)
70 – 120 psig (4.9 – 8.43 kg/cm
7.8 cfm (.093 m ) @
3
80 psi (5.62 kg/cm )
2
Up to 300–350 Nails
1-1/2" – 3-1/4"
(38.1 – 82.6 mm)
0.099" – .131" (2.5 – 3.3 mm)
15° wire weld
D. Contact trip
E. Magazine latch
F. Magazine
)
2