Abicor Binzel ABITIG MT Mode D'emploi page 35

®
ABITIG MT
7 Operation
DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
During the welding of work-pieces that have been degreased with chlorine-
containing solvents phosgene gas is formed.
• Do not inhale fumes and vapors, ensure sufficient supply of fresh air.
• Rinse work-pieces with clear water prior to welding, Do not place
degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding work spraying sparks, glowing work-pieces or hot slag can
produce flames.
• Check work area for seats of fire.
• Make suitable fire extinguishing materials available at the workplace.
• Allow work-pieces to cool down after welding.
• Prior to performing welding work, fasten the ground clamp properly to
the work-piece or the welding table.
WARNING
Dazzling of the eyes
The arc produced by welding may damage the eyes.
• Wear protective clothing or eye protection.
NOTICE
• The TIG welding torch may only be operated by qualified personnel (in
Germany see TRBS 1203).
• As the TIG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and welding power supply, must be observed during operation.
• For TIG welding, ensure that all the parameters are set at the power
supply for your welding task.
7 Operation
EN - 15