HOMCOM 820-486V80 Mode D'emploi page 24

EN
Safety Cut-Off
• This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
Due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
•
minutes. Reconnect the supply to the mains and switch on the appliance.
Cleaning
1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the heater.
4. When the heater is not used for a long time, it should be protected from dust and
stored in a clean dry place.
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
23