HOMCOM 820-486V80 Mode D'emploi page 23

EN
"bh":high
•
"bc":middle
•
"bL":low
•
"bo":off
•
5.Bottom light setting
Press the bottom light setting button④ to change the color, with 10 different color
•
changes available
C1→C2→C3→C4→C5→C6→C7→C8→C9→10→C1
•
6.backlight setting
Press the backlight setting button⑤ to change the color, with 11 different color changes
•
available
F1→F2→F3→F4→F5→F6→F7→F8→F9→10→11→F1
•
7.Timing function
Press the timer button⑨ to set the timer. Press once to add 1 hour and set the range
•
from 1 to 12 hours
8.cycle light function
Press the button⑧ to Set cycle light. Press again to turn off cycle light.
•
Remote control
• The standby switch located at the front right hand side above the fire must be first
switch on.
• It takes some time for the receiver to respond to the transmitter. Do not PRESS the
buttons more than once within two seconds for correct operation.
BATTERY REPLACEMENT-REMOTE CONTROL
1. Batteries Not Included.
2. To replace the existing battery remove the battery holder.
3. To remove the battery holder turn remote onto rear side and press the left side lever
towards the center while pulling the battery holder out using the slot provided.
4. Replace existing battery, type CR2025, with a new battery and reinstall the battery
holder into the remote by sliding it into position, as shown:
Battery (CR 2025)
Battery Holder
Remote
(Rear Side)
22