HOMCOM 820-486V80 Mode D'emploi page 22

EN
Location of Controls and Operation
Button and remote control diagram
1.Powering the Fireplace
• Push the Power button① to supply power to all functions of the fireplace and put the
fireplace in a standby mode.
• Push the Power button again to turn off all functions.
2.Adjusting the Heater
• Turns the Heater On and Off, pressing the button⑥ on the remote or control panel.
Cycles the unit through the three settings:
• 'H2',High Heat. indicated icon on display.
• 'H1',Low Heat. Indicated icon on display.
• Blower and Heater OF, Indicated icon is off.
3.Adjusting the thermostat
• Press the temperature button ②&③ on the control panel to change the setting
temperature.
• The thermostat setting range is 15°°C-35°C(59°F-95°F).The default temperature
setting is 25°C(77°F)
• The thermostat is adjustable by 1°C(1°F) increments by pressing the Plus or Minus"+ -"
• Press and hold the temperature button ② for 5 seconds to switch between Fahrenheit
degree and Celsius degrees.
4.Adjusting the Brightness
Press the Brightness button⑦ on the remote control to change the brightness
•
between the 4 settings: High, Middle, Low and off . Indicated by the second digit on the
Floating Display changing to show.
21