Battery - Ivoclar Vivadent bluephase Mode D'emploi

Battery

We recommend fully charging the battery before the first
use.
If the battery is fully charged, it features a curing capaci-
ty of approximately 60 minutes.
Slide the battery straight into the handpiece until you
hear and feel it click into place.
Place the handpiece in the corresponding rest in the
charging base. If a sleeve is used, please remove it before
you charge the battery.
If possible, use the light always with a fully charged
battery. This will prolong the service life. It is therefore
recommended to place the handpiece into the charging
base after each patient.
The indicator on the display shows that the battery is
being charged.
The battery is fully charged as soon as the
display is dark (if the battery is completely
empty, charging takes approximately 2 h).
However, the handpiece may be taken off
the charging base with reduced capacity
and used for polymerization at any time.
Charging status of the battery
With the handpiece switched on, the current charging
status is shown on the display as follows:
Battery fully charged (curing capacity of
approximately 60 minutes)
Battery half full
Reserve (The last bar in the battery indica-
tor is red in the reserve mode. The battery
has to be charged as soon as possible.)
Empty battery
If the battery is completely empty, the
handpiece automatically switches to the
stand-by mode. The light can no longer be
called up and the curing program and cur-
ing time can no longer be set. However, the
handpiece can be used in the Click & Cure
corded operation.
9