Direct Water Drainage - Kruger AIRSEC 3000 Mode D'emploi

10

Direct water drainage

If required, the water removed from the
air can also be drained directly away.
• Remove the water collecting bucket
(7)
• Knock out the prepared plastic part
(10) on the left-hand side of the appli-
ance
• Introduce a hose (available from trade
outlets, inside diameter 1 4 mm) through
the new opening and push over the
end of the outlet pipe
• Ensuring that a steep gradient is
maintained, lead the other end of the
hose into a discharge pipe. Ensure that
no water can run back into the appli-
ance and water flow is not obstructed
in the hose.
• Re-insert the water bucket
Cleaning
The cooling unit is hermetically sealed;
the fan bearings are permanently lubri-
cated and therefore require no mainten-
ance.
• Remove the mains plug from the wall
socket.
• Wipe the housing with a soft, dry cloth.
In the case of light soiling use a damp
cloth with a mild cleaning agent.
• Grip the air filter frame (5) at the indent
and pull out.
• Remove any dust and lint from the
white filter mesh with a brush or vac-
uum cleaner (every 3 – 4 weeks).
• Re-insert the filter and filter frame into
the appliance.
• Re-insert the mains plug into the wall
socket.
Heavy soiling will require the inside of
the appliance to be cleaned. This main-
tenance must be carried out by a refrig-
eration specialist.
TROUBLESHOOTING
Please check the following points before
taking the appliance to your specialist
retailer:
A. The appliance does not
operate
• Has the mains plug been inserted cor-
rectly?
• Is the fuse in your electrical switchbox
OK?
• Is the mains cable and/or any exten-
sion cord being used in good working
condition?
• Is the water collecting bucket empty?
• Has the water collecting bucket been
replaced correctly?
• Is the room humidity level above that
set on the appliance?
• Have you waited three minutes before
attempting to switch on your appliance
again? The dehumidifier is fitted with
compressor protection. After being