Uninstallation - Girsberger ATC Manuel D'utilisation

10. Uninstallation

Before uninstalling, perform a functional check on the entire system!
1. Uncover all transmitters, clean and dry them.
2. Disconnect the antenna cable from the control unit.
3. Remove the control unit.
4. Remove the information board.
5. Remove the telescopic mast. The antenna may remain mounted on the mast.
In order to avoid damage by humidity or water, all of the following steps must be done indoors!
6. Open the transmitters, remove the batteries and re-close the transmitters.
7. Open the control unit, remove the batteries and re-close the control unit.
8. Store all equipment in a dry place until the next setup.
49