Expert Mode; Starting Point; Selecting The Operating Mode - Girsberger ATC Manuel D'utilisation

5. Expert Mode

In expert mode, every transmitter can be activated and deactivated individually.
Three consecutive probe hits, one second apart each, on the probing surface will cause an optical and
acoustic indication at the control unit.
The activated transmitters keep transmitting even after a probe hit. This corresponds to a realistic situation.
Most transceivers provide facilities to mark found transmitters.

5.1 Starting Point

V i ct i m s : 0
T i me : 1 0 m 00s

5.2 Selecting the Operating Mode

Vict : 1 On: no
For entering the expert mode, the system must be in standard mode
(also see section 4.1)
Pressing the START / STOP key for at least five seconds enters the expert
mode. To return to standard mode, press the START / STOP key again for
at least five seconds.
37