Ryobi RM480e Instructions Originales page 3

• Should the mower remain plugged into the
charger when not in use?
Yes, continually charge the mower when
not in use,
• Vimat is the recommended tyre pressure,
and now often should
pressure in the tyres?
For best performance, the tyre pressure
should be 1.6 bar, Check
pressure before each use.
• What can cause the blades to stop during
— Check the battery level indicator, The
deck motor turns off when the battery
power gets low to allow you enough time
to drive back to the charging location,
Drive back and charge the battery
immediately.
— If the the battery level is not low, slow
down or raise the cutting deck to a
higher level High load applications can
also cause one or both
stop.
Che=k that the side discharge chute is
properly closed. push down the side
discharge chute, and make sure that it
fully presses the side discharge interlock
switch.
• When coasting downhill, why does the
mower sometimes accelerates
sometimes does not?
For your safety and better performance,
the mower is designed to automatically
limit its speed when travelling on a slope,
which may cause fluctuations in speed.
Lihy does the mower make a beeping
sound when I drive in reverse?
— To alert anyone nearby of the mowers
location.
• When operating the mower; how do I bring
the mower to a complete stop?
To stop the mower, Step
pedal on the operator's
product is not a hydrostatic drive,
• Mdhy does the mower make a beeping
sound when I leave the seat?
— The parking brake
engaged or the start key is still installed
and in the ON position. Always remove
42 | English
FREQUENTLY ASKED QUESTIONS
the key when the mower is not in use.
When should I use the parking brake?
Always engage the parking brake before
getting off the mower.
Can I rinse
I check the air
garden hose?
DOnot clean the product with water, use
a blower OTair compressor to clean it,
the tyre
deck motors to
and
the brake
left side. This
has not been
off the mower deck with a