Care, Maintenance And Disposal; Replacement Parts; Troubleshooting; Specifications - Beurer FC 55 Mode D'emploi

8. Care, Maintenance and Disposal

Before cleaning, remove the brush from the Power Head. Clean brushes thoroughly with clean running water
after each use. Clean the Power Head with a soft, damp cloth. Do not use abrasive cleaners. Replace brushes
every 4-6 months or as needed. To reorder a replacement brush head, contact customer service.
Disposal
Observe the local regulations for material disposal. Dispose of the device in accordance with local
regulations. If you have any questions, please contact the local authorities responsible for waste disposal.

9. Replacement parts

Please contact Customer Service to obtain the following replacement parts.
Brush type
Cleansing attachment
Exfoliation attachment

10. Troubleshooting

Problem
The device does not charge.
The device will not switch on.
The device does not cleanse
as well as it did at the
beginning.

11. Specifications

Power Adapter
Dimensions
Weight
Battery Capacity
Nominal Voltage
Type

12. FCC Compliance Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
Intended purpose
Daily cleansing
Gentle exfoliation in the
shower
Ensure that the power adapter is connected to a functioning socket. If it is
connected correctly and the device still fails to charge, contact Customer
Services.
Charge the device as described in these instructions for use. If it is still not
possible to switch on the device, contact Customer Services.
The brush is worn. Replace the brush head. Replacement heads can be
ordered from Customer Service.
100 - 240 VAC; 50/60 Hz; 0.2 A
With Brush: 2.8 x 3.9 x 3.9 in (7.2 x 10 x 10 cm)
Handle: 15.3 x 3.8 x 1.5 in (39 x 9.7 x 3.9 cm)
With Brush: approx. 9.5 oz (270 g)
Handle: approx. 4.9 oz (140 g)
800 mAh
3.7 Volts
Lithium-ion
Replace
After 4 months
After 4 months
Solution
6
Item number
164.077
164.078