Appendix B : Installation Procedure Of "Plex" Chute On Nv5 Banknote Reader - Comestero Group SimplyCoin Mode D'emploi

_________________________________________________________________________________
POWER SUPPLY
Pin Direction
1
2
RM5 PROGRAMMER
Pin Direction
1
2
3 OUTPUT
4 INPUT
5
6
AL-HP1, AL-HP2
Pin Direction
1
2
3
HP1, HP2
Pin Direction
1 INPUT
2 INPUT
3 INPUT
4 OUTPUT
Signal
- 24 Vac
- 24 Vac
Signal
GND
+5V
TX
RX
N.U.
N.U.
Signal
- + 12 Vdc
- GND
- + 24 Vdc
Signal
EMPTY
COIN OUT
ALARM
CONTROL
43
_________________________________________________________________________________
APPENDIX B: INSTALLATION PROCEDURE OF "PLEX" CHUTE ON NV5
BANKNOTE READER
The application of the "PLEX" chute on NV5 banknote reader results in an easier passage of the
banknote inside the cash..
INSTALLATION INSTRUCTIONS
1. Clean the metal blade with a cloth to
remove any dust.
2. Remove the protecting film from the adhesive
on the back of the "PLEX".
3. Hold NV5 banknote reader with your left hand.
4. Applicare Apply the "PLEX" on the metal blade with a slight
pressure for a better adherence.
Note: It is advisable to enable the anti-fishing function as described in the relevant brochure.
44