Replacing The Lamp Tubes/Starter; Cleaning And Care Of The Unit; Important; Disposal - Beurer TL 80 Mode D'emploi

5 Switching off the lamp
 Press the On/Off button. The tubes turn off. Pull the mains plug from the socket.
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it
away and/or pack it up!

7. Replacing the lamp tubes/starter

The service life of the fluorescent tubes is on average 10,000 hours. If one tube needs replacing, both fluo-
rescent tubes must be replaced with new tubes of the same type. For this purpose, contact a retailer, an
authorised service centre or appropriately qualified personnel or contact the customer service.
The following tubes are approved as replacement:
• Philips – PL-L36W/865/4P
• The manufacturer's tubes are available with the order number 162.942 from customer support
Warning
• For environmental reasons, do not dispose of the fluorescent tubes with the household waste. Dis-
pose of the unit at a suitable local collection or recycling point. Please contact the local authorities
responsible for waste disposal.
• Unplug the device, to avoid the risk of electrocution.
• Take care when handling fluorescent tubes to avoid the risk of cut injuries.

8. Cleaning and care of the unit

The unit should be cleaned occasionally.

Important

• Ensure that no water penetrates inside the unit!
Before you clean the unit, always switch it off, unplug it and let it cool off.
• Do not wash the unit in a washing machine!
Clean using a damp cloth, to which you can apply a little detergent if necessary.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed
onto the unit. The unit must be operated only when it is completely dry.
Do not use abrasive detergents and never immerse the unit in water.

9. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the device at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you
have any questions, please contact the local authorities responsible for waste disposal.

10. Technical specifications

Dimensions (WHD)
Weight
Lighting elements
Power
Light intensity
Radiation
Product classification
Mains connection
310 x 555 x 255 mm
2,7 kg
FSL-YDW-36HRR
72 watts
10,000 lux (Distance: approx. 20 cm)
Output of radiation beyond the visible spectrum (infrared and UV)
is so low that it is harmless to eyes and skin.
Protection against moisture: IP21
Electrical protection class: class II
230 V ~, 50 Hz
12