Renkforce 1488542 Mode D'emploi page 26

The device must be mounted out of normal reach.
Illuminated objects must be at least 0.5 m away from the device's light emission source. Easily flammable
materials such as decorative fabrics must also have a distance of at least 0,5 m to the device. Otherwise,
such objects may catch fire!
When mounting the product, make sure that the mains cable is neither jammed nor damaged by sharp
edges.
During installation or service work, the area below the place of installation must be cordoned off.
The setup/installation surface or fixture must be designed to carry ten times the load capacity for at least
one hour without any permanent damaging deformation.
It is also essential that the device is secured by means of a second safety restraint that is independent of
the actual mounting supports when installing it in an elevated position. No part of the installation must fall
down if the main suspension system fails.
Observe all relevant regulations of your country when mounting/installing the device.
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical connections)
must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Attach the enclosed mounting brackets to the side of the housing with the two fastening screws and the four rubber
discs. Please observe the order: Fastening screw - rubber disc - mounting bracket - rubber disc - housing.
• If you want to set up the effect light, turn the two mounting brackets so that they form a base (pull the longer
mounting bracket forward, shorter mounting bracket to the rear) and then tighten the fastening screws. Ensure a
safe stance here.
• If you want to suspend the effect light, turn the mounting bracket up.
• Install the effect beamer on the ceiling, the wall or a suitable crossbeam with the mounting bracket. There are
attachment holes in the mounting bracket for mounting with screws. The assembly must never swing freely.
• Secure the device with assembly equipment that is compatible with the attachment surface and suitable for carrying
the weight of the effect light.
• Set the desired tilt angle and tighten the two fastening screws well to the assembly bracket.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety retention rope or
the net must be designed to support the effect light in the event of failure of the main support system independently
of the main attachment.
Many provisions and requirements must be observed for commercial or public use. They are only described
here in excerpts. You as the operator are responsible for ensuring that they are complied with at installation
and operation.
26