Helite Hip'Safe Manuel D'utilisation page 25

CO2 CARTRIDGE
The belt is sold with a new and usable CO2 cartridge ready to work.To install a new one, you
must screw it directly in the black cylinder.
Black cylinder
The cartridge is for single use only and must be replaced after each inflation. We advise to
store 1 or 2 cartridges and keep them available in the event of fall. It is possible to order CO2
replacement cartridges on our website www.helite.com or at one of our dealers.
CAUTION
- The CO2 cartridges are for single use only and must be replaced after each inflation.
- The CO2 cartridge must be a Helite branded cartridge ( GG 50cc / GG 60cc). Do not use any other cartridge
to replace the used one.
- The cartridge must be entirely screwed. Never connect the cartridge before screwing it entirely in the black
cylinder.
- The cartridge should be stored and used in temperatures below 45°C. Do not leave full cartridges
in the car in high temperatures for example.
- Never let the cartridge fall down.
- If rust or other corrosive marks appear on the outer surface of the cartridges, change them immediately
and discard the cartridge.
- Never cut the cartridge, do not throw into fire.
- Keep out of children's reach.
TABLE OF SIZE
The belt must fit perfectly over your hips to ensure an optimal protection. Please verify that it
is not too tight or too loose. The belt is available in five different sizes ( T1, T2, T3,T4 and T5). It
is also possible to adjust the belt thanks to the strap under the belt. To find your size, you need
to measure your waist (with clothes on) at the navel and look at the table below:
Waist line
Tour de taille
Taillenumfang
(in centimeters and
inches)
User Guide
Product size
T1 T2
65-75 cm
70-90 cm
(25-29 '') (27-35 '')
Helite CO2 Cartridge
/ Taille du produit / Produktgröße
T3 T4
85-100 cm 95-115 cm
(33-39 '') (37-45 '')
25
T5
110-125 cm
(43-49'')