Helite Hip'Safe Manuel D'utilisation page 22

22
3. Buckling the belt will turn the system ON
SYSTEM ON- OFF
ON
HOW TO PLACE THE BELT CORRECTLY?
Pull the belt over your
hips and close it to
activate the system.
WRONG POSITIONS
The belt is not turned.
HOW TO KNOW IF HIP'SAFE IS ON THE RIGHT SIDE?
CORRECT
- the symbols "up" and the figure point
upwards.
- A single "beep" when the system is
ready to function.
- Green LED is on.
User Guide
Check if the belt is in the
right position. (Picto "Up"
and the figure are upward)
The belt is on the wrong side
(the arrow must point upwards).
- The symbols "UP" and the figure are
backwards.
- A 10 seconds continous beep.
- Red LED is on.
Turn and center the belt.
(Buckle on your back, arrow
on your front)
The belt is not centered.
INCORRECT
OFF