Num'axes PROTECTION PIE1061 Guide D'utilisation page 27

The settings presented below can be made directly on the LCD screen of the device
but also in the free mobile application available on Android and iOS.
GENERAL MENU (displayed by default)
Settings
Mode
PIR interval
Time Lapse setting
Programmable options
(default settings in bold characters)
Photo | Video | Photo + Video | Time Lapse
− Photo: the camera will only shoot photos.
− Video: the camera will only shoot videos.
− Photo + Video: upon the same trigger event, the
camera will shoot photo(s) first then a video.
− Time Lapse: automatic photo capture at a pre-set time
interval (see "Time Lapse setting" parameter to set the
time interval).
Default PIR interval: 20 seconds
Programmable from 5 seconds to 59 minutes 59 seconds
This setting is disabled if the selected Mode is "Time
Lapse".
Press OK to set the desired time interval between
photos/videos upon motion detection by the PIR sensor.
Example: if the PIR interval is set to "01 min 00 sec", the
camera will wait 1 minute between photo/video
recordings with motion.
This parameter is enabled only if the selected Mode is
"Time Lapse".
Press OK to set the interval between automatic photo
captures.
H : M : S
00 00 30
Time Lapse programmable from 00:00:05 up to 23:59:59.
Example: if Time Lapse is set to 00:30:00, the camera will
automatically capture photos every 30 minutes.
The "Time Lapse" feature can work together with the
"Timer" feature.
Guide PIE1061 – Août 2025 – ind. E - 27/140