Num'axes PROTECTION PIE1061 Guide D'utilisation page 26

If synchronization does not occur immediately, check that the "Photo Sending
Frequency" setting is set to "Instantly" (this setting is found under "Instantly – Group"
– Use the  button to scroll down).
10. Operation
10.1. Turn ON the camera | ON
Put the switch in the ON position; the camera is ready to work.
The red start-up indicator light located on the front cover will blink and the LCD
display will count down 5 seconds. This interval allows you time to close the camera
front cover and leave the monitored area.
Once in the ON mode, the camera will take photos and/or videos according to its
current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings.
10.2. Turn OFF the camera | OFF
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very low
level. Therefore, please remove the batteries if the camera will not be used for a long
time period.
The OFF mode is the "safe mode" for actions such as: replacing the memory card or
batteries, or transporting the camera.
10.3. Customizing the operating settings | SETUP
To enter the camera settings MENU, slide the switch to the SETUP position (the LCD
screen will light up), then press the MENU button.
You can navigate the setting interface by pressing , ,  or . Press OK for
selection, press MENU to exit to the previous page.
Guide PIE1061 – Août 2025 – ind. E - 26/140
Once your camera is synchronized, the
following information will appear in
the app:
‒ Remaining energy level
‒ Signal strength
‒ Remaining storage space on your
SD card
‒ Number of new (unread) files