Fagor PL-200 Manuel D'utilisation page 11

• Do not turn the iron towards people when
it is expelling steam. This is extremely
dangerous.
• Do not use the iron on very wet fabrics.
• Do not mix stain-removers or similar
products on fabrics to be ironed.
• Unplug the iron when not in use. Never
leave plugged in when not absolutely
necessary.
• If you decide never to use the appliance
again, remove the plug from the socket
and render it useless by cutting the
power cable.
• The iron is not to be used if it has been
dropped, if there are visible signs of
damage or if it is leaking.
• Keep electrical appliances out of reach
from Children or infirm persons. Do not
let them use the appliances without
supervision.
• The user must not leave the iron
unattended while it is connected to the
supply.
• The plug of the supply cord must be
removed from the socket-outlet before
the water reservoir is filled with water
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety
• Children should be supervised to ensure
that they do not play with the appliance
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.
• This product is designed for domestic
use and to be used with tap water.
Do not put perfume, vinegar or other
chemicals in the tank. This appliance
is not designed to work with these
chemicals.
4. INSTRUCTIONS FOR USE
• This steamer is designed to be used in an
upright position on hanging garments. (the
garment must be in vertical position, for
example, hanging in a hanger) Refrain from
using the steamer in or on garments in an
horizontal position.
• Fill the water tank with at least 5ml of water.
Do not exceed the "MAX" level (Fig. 2)
• Hold the appliance safely, firmly and in an
upright position before attaching the fabric
brush onto its steam head. The fabric brush
can be attached either way and will lock into
position with an audible click (Fig. 3)
• Connect the appliance to a main supply
outlet. The red pilot red will turn on
indicating the steamer is heating up. When
the light is turns off, the steamer is ready to
use (Fig. 4)
• Press and hold onto the steam button with
the steamer facing away from you in an
upright position. Gently press the fabric
brush against the garment (Fig. 5)
• Depending on the thickness and type of
the garments, it is suggested to apply more
steaming time, in order to lead more steam
to penetrate.
• When using the steamer, the red light will
occasionally turn on, indicating the steamer
is heating up. This does not affect the use of
the steamer.
• When pressing the steam button, if the
steamer doesn't generate steam and
produces a different sound, release the
button immediately and fill the water tank.
• If using the steamer without the fabric brush,
keep a distance of at least 5cm between the
steam head and the garments.
• After use, always disconnect the mains
supply and empty the water tank (Fig.6 & 7)
• NOTE: Do not touch the steam head
during or after use, wait until the steamer
completely cools.
• NOTE: To completely disconnect from
the power, the mains plug must be
disconnected from the mains socket. (Do
not leave the unit connected during periods
of none use).
• NOTE: Do not use the appliance directly
on the body, animals or when wearing the
garments.
10