Replacing The Blades (Fig. 10); Software Update; Repairing The Boundary Wire; Storage - Powerplus Powdpgrms1 Mode D'emploi

11.2.1

Replacing the blades (Fig. 10)

ATTENTION! When fitting new blades, make sure you replace ALL the
blades. Always use new screws when fitting blades. This is important to
ensure blade retention. Failure to use screws could cause serious injury.
ATTENTION! Wear gloves when handling the blade. Only use original
replacement parts specified for this mower. Powerplus spare blades and
screws item reference number: POWACG9102.
It's recommended that replace the blades within 2-3 months.
There are 3 blades on the robot mower, which are screwed into the blade disc. All 3 blades
and screws must be replaced at the same time to obtain a balanced cutting system.
▪
Set the on/off switch of the mower to "OFF".
▪
Turn the robot mower upside down. Place the robot mower on a soft and clean surface to
avoid scratching the body and the cover.
▪
Rotate the blade disc so that its holes align with the hole in the machine frame and insert
screw driver to block the blade disc.
▪
Remove the 3 screws with a screwdriver.
▪
Remove each blade and screw.
▪
Fasten new blades and screws.
▪
Check that the blades can pivot freely.
11.2.2

Software update

The USB connection (Fig. 9) is for the after sale service only.
The software can be update through the APP. Please refer to the operation manual of the
APP.
11.2.3

Repairing the boundary wire

If the boundary wire (17) gets severed at any point, use the supplied cable connectors (15) to
repair it. To do so, insert both ends of the severed boundary wire (17) into the cable connector
(15) and squeeze it together with the help of a pair of pliers. Connect the power plug to the
socket out-let. (The boundary cable must not be dismantled when inserted in the cable
connector! ) Then check whether it is working properly by checking the LED indicator (21) on
the charging station (18).
Green led flashing: there is still a defect in the boundary wire
Green LED is permanently lit: the boundary wire is OK.

12 STORAGE

Fully charge up the rechargeable battery (22) before putting it into storage over winter and
take the rechargeable battery (22) out
of the equipment. Disconnect the adapter(12) from the socket outlet and the charging station
(18). The boundary wire can be left outdoors during winter. Disconnect the boundary wire (17)
from the charging station and make sure that the connections are protected against corrosion.
It is recommended to cover or protect the charging station.
Store the equipment and accessories out of children's reach in a dark and dry place at above
freezing temperature. The ideal storage temperature is between 0 and 50°C. Store the
equipment in its original packaging.
Copyright © 2024 VARO
POWDPG6010
P a g e | 17
EN
www.varo.com