Switching On And Checking The Installation; Operation; Control Panel; Explanation Of The Buttons On The Control Panel (Fig. 7A) - Powerplus Powdpgrms1 Mode D'emploi

The LED indicator (20 - Red) on the charging station (18) should light up red and stay on
permanently, the LED indicator (21 - Green) on the charging station (18) should light up green
and stay on permanently. If the LED indicators does not light up, check the connections first. If
the LED indicator (21) is blinking, the boundary wire is not properly connected. Please read
the "Indicators on the charging station and troubleshooting" table at the end of these
operating instructions.
7.8

Switching on and checking the installation

As soon as the green LED indicator (21) on the charging station (18) lights up green
permanently, the mowing area is ready for the robot mower. Please check first that all the
fixing pegs (13) on the boundary wire (17) have been fully tapped in. Place the robot mower
about 3 m to the front of the charging station (18) in front of the boundary wire (17) at a
distance of max.1m.
The robot mower needs to be facing the boundary wire (17) at an angle of 90° (Fig. 6b).
Press the "POWER" (27) button on the control panel (2) for three seconds. Unlock the robot
mower using the PIN and confirm the entry with the "OK" (28) button (see chapter
"Locking mechanism / PIN").
Press the "HOME" (30) button and then press the "OK" (28) button again. The robot
mower starts to run toward the boundary wire, than will now follow the boundary wire (17) in a
clockwise direction. Observe the robot mower during the complete trip along the boundary
wire (17) until it is back in the charging station (18). If the robot mower has any problems at
any points, correct the boundary wire (17) if necessary and repeat the operation. If any
problems occur with docking, you may need to reposition the charging station (18) sideways
until docking works without any problems.
To stop the robot mower at any time, press the red "STOP" button (3). When you press the
"STOP" button (3), the robot mower will come to a stop and wait for further instructions.

8 OPERATION

8.1

Control panel

The robot mower has already been programmed at the factory and default settings have been
made for it. However, these can be changed if required. Even though the factory settings will
be suitable for most gardens, you should still familiarize yourself with the available options
nevertheless.
8.1.1

Explanation of the Buttons on the control panel (Fig. 7a)

"POWER" button (27): Switch the robot mower on and off by pressing the Power button for
▪
over 3 seconds.
"OK" button (28): The button is used to confirm your operations via the control panel.
▪
"START" button (29): Press "START" button then press "OK" button to manually start the
▪
mower to work; or press "▷"button to move the characters on the LED display.
"HOME" button (30): Press "Home" button then press "OK" button to manually let the
▪
mower go back to charging station.
8.1.2

Explanation of the characters on the LED display (Fig. 7b)

Please refer to "Error codes on the LED display and troubleshooting" and "Operation codes
on the LED display". at the end of these operating instructions.
See Explanation of the Figures on the control panel (Fig. 7c)
When WIFI connects to the router but not the server flashes every 2 seconds.
WIFI connected to the server, always bright.
Copyright © 2024 VARO
POWDPG6010
P a g e | 13
EN
www.varo.com