Cutting Height Adjustment Facility; Locking Mechanism / Pin; Display Unlock; Control Of The Robot Mower - Powerplus Powdpgrms1 Mode D'emploi

8.2

Cutting height adjustment facility

Important! Adjust the cutting height only when the robot mower has been
switched off.
Do this by pressing the STOP button (3). The mowing height adjustment dial (4) allows the
cutting height of the robot mower to be set to finitely adjustable settings between 30 and 60
mm, which can be viewed on the scale.
If the grass is taller than 60 mm, it has to be mowed to a maximum of 60 mm first to avoid
exposing the robot mower to excessive load and adversely affecting its operating efficiency.
Use a conventional lawnmower to do this. After installation has been completed, the cutting
height can be adjusted using the mowing height adjustment dial (4). Always start with a higher
cutting height and reduce it in small steps until you reach the desired height.
8.3

Locking mechanism / PIN

The locking mechanism prevents the unauthorized use of the robot mower without a valid
code. You have to enter a personal four-digit security code for this.
8.3.1

Display unlock

Before you start using the robot mower, you have to enter the correct PIN (standard PIN: "0-
0-0-0"). When you input the PIN, press the "HOME" button (30) to switch the number from 0
to 9 and press the "START" button (29) to move the characters on the LED display. Enter the
PIN in sequence and confirm the entry with the "OK" button (28). The control functions will be
unlocked and the LED display will display time, for example, display 23:45. (For the meaning
of the codes, please refer to "12.Operation codes on the LED display".)
8.4

Control of the robot mower

TIP: Test boundary procedure
To ensure that the boundary wire cable is installed correctly and that the mower can move free
over the boundary wire and finally stops in the charging station please follow instructions:
place the mower +/- 50cm behind the charging station over de boundary wire cable. Unlock
the display and press "Home" and then "Start" button. Check if the mower moves free over the
complete length of the boundary wire cable. At the end the mower should stop in the charging
station. If everything is Ok please proceed following steps below.
8.4.1

Starting procedure

1. If the Display locked, Unlock the control panel (2).
Press the "START" button (29) first.
2.
To confirm the starting procedure, press the "OK" button (28).
3.
If the calendar has been set up via the APP, the robot mower will start at the same time and
work on the same area every day.
The battery charge level is monitored during the work time and displayed via the battery LED.
Whenever the battery capacity drops to 36%, the robot mower automatically returns to the
charging station (18).
8.4.2

Stopping mowing

To bring the robot mower to an immediate stop, press the "STOP" button (3).
1.
2. If the Display locked, Unlock the control panel (2).
Press the "HOME" button (30) followed by the "OK" button (28) to send the robot mower
3.
along the boundary wire (17) and back to the charging station (18).
Copyright © 2024 VARO
POWDPG6010
P a g e | 14
EN
www.varo.com