Spiral And Spot Cut (Only If Connected With Bluetooth); Multi-Zone Management; Sensors; Lift Sensor - Powerplus Powdpgrms1 Mode D'emploi

All zones that you wish to protect within the lawn area – e.g. garden ponds, trees, furniture or
lower beds – must be cordoned of by the boundary wire (17). The boundary wire (17) must
form a closed circuit.
If the robot mower bumps into an obstacle within the mowing area, it reverses and then
continues mowing in a different direction.
7.2.2

Spiral and spot cut (Only if connected with Bluetooth)

Spot mowing mode can be used when you have an area of tall grass to mow. Manually place
the robot mower in the center of the area and activate the spot mowing mode, after which the
mower will cut the grass in a systematic spiral model.
7.2.3

Multi-zone management

With the ability to start mowing from the charging station at no more than 5 different remote lo-
cations along the boundary line, it is ensured that each zone can be cut by the mower to adapt
to multiple zone scenarios.
7.3

Sensors

The robot mower is equipped with a number of safety sensors.
7.3.1

Lift sensor:

If the robot mower is lifted both fully from the ground and when it is lifted from only a single
point causing it to be tilted, the rotation of the blades (9) are stopped.
7.3.2

Tilt sensor:

If the robot mower tilts severely in any direction, the robot mower and the rotation of the
blades (9) are stopped immediately.
7.3.3

Obstruction sensor:

The robot mower is able to detect obstacles in its path. If the robot mower collides with an
obstacle, the robot mower will be stopped immediately and the mower will reverse away from
the obstacle.
7.3.4

Rain sensor:

The robot mower is equipped with a rain sensor (5) to prevent the robot mower from operating
in the rain. The robot mower returns to the charging station (18) when it detects rain and is
completely recharged there.
In the factory state, this sensor is deactivated and can be activated via the APP including
delay times.
Warning! Do not short-circuit the rain sensor with metal or any other
conductive material.
This will impede the correct operation of the robot mower.
Copyright © 2024 VARO
Set-up and further instructions can be done via the APP.
POWDPG6010
P a g e | 8
EN
www.varo.com