Publicité
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re-
used or recycled.
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domes-
tic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and elec-
tronic equipment (WEEE). This product must be dis-
posed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment.
17. Troubleshooting
Fault
Possible causes
Blade dissolves after
To slightly tightened fastening nut
switching off the
engine
Engine will not start
Failure mains fuse
Defective extension cable
Connections on motor or switch not in
order
Motor or switch faulty
Motor will not work,
Cross section of the extension cable is not
the fuse is active
sufficient
Overload by a blunt saw blade
Fire marks on the
Blunt saw blade
cutting surface
Wrong saw blade
38 | GB
www.scheppach.com / service@scheppach.com / +800 4002 4002
Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electron-
ic equipment. By properly disposing of this product,
you are also contributing to the effective use of nat-
ural resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
See „Electrical connection"
Change saw blade
Have saw blade sharpened (only by an
authorised sharpening specialist) or change it
Change saw blade
Publicité
