Publicité
BEFORE INSTALLING YOUR DISHWASHER
Before connecting your dishwasher to the power supply, check that the voltage
stated on the rating label of your appliance corresponds to the voltage in your
home. The appliance must be grounded. The manufacturer is not responsible for
damages that may occur as a result of usage without grounding.
WARNING:
Disconnect electrical power before installing your dishwasher.
INSTALLATION INSTRUCTIONS
Positioning The Appliance
Position the appliance in the desired location. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or walls. The dishwasher
is equipped with water supply and drain hoses that can be positioned either to
the right or the left sides to facilitate proper installation.
Cold Water Connection
The installation of the hose should be done by professionals.
Connect the supplied water supply hose to a
threaded 3/4" connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used
for an extended period of time, let the water run to
make sure that the water is clear. This precaution
is needed to avoid the risk of the water inlet to be
blocked and damage the appliance.
Connection of the Drain Hose
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it
run into the sink, making sure to avoid bending or crimping it. The height of drain
pipe must be less than 1000mm. The free end of the hose must not be immersed
in water to avoid the back flow of it.
FR
EN
NL
PT
112
Publicité
