STARTING A WASH CYCLE
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
-
Ensure that they are clean and properly positioned. See the section
Cleaning and Maintenance.
4. Check that there is rinse aid and salt.
5. Load the dishes.
-
Ensure that the spray arm can rotate freely.
6. Add the required amount of detergent into the dispenser according to the
Washing Program chart.
7. Close the dishwasher door securely.
8. Press
to switch on the dishwasher.
9. Repeatedy press
-
The corresponding programme indicator light will illuminate.
Delay Timer:
-
You can start the dishwasher cycle 3 hours, 6 hours, 9 hours or 12 hours
later.
Press
and then repteadly press
delay hour indicator light will illuminate.
10. If you want to activate other functions, repeatedly press
desired function indicator light illuminates.
-
The extra drying function
90 min programmes. When this function is activated, the dishwasher
will increase temperature at the end of a washing programme to
improve drying.
-
If you want to perform a half load wash, you can choose this function
to save energy and water. This function can only be used with
ECO, Glass and 90 min.
11. Press
to start washing.
-
If delay timer is set, the selected delay hour indictor light will flash. After
the delay time has elapsed, the appliance will automatically operate.
12. After the program has ended, the diswasher will buzz and stop.
-
If the dishwasher is set for a delay start, the dishwasher will not buzz.
-
After 15 minutes, the dishwasher will turn off.
FR
to select the desired washing program.
can only be used with the ECO, Glass and
NL
PT
to preset a time. The selected
until the
EN
127