Publicité
WARNINGS!
•
Do not over tighten the filters. Put the filters back in sequence securely,
otherwise coarse debris could get into the system and cause a blockage.
•
Never use the dishwasher without filters in place. Improper replacement of
the filters may reduce the performance level of the appliance and damage
dishes and utensils.
Cleaning the spray arms
It is necessary to clean the spray arms regularly, otherwise hard water chemicals
will clog the spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
1.
To remove the upper spray
arm, hold the nut in the
centre still and rotate the
spray arm clockwise to
remove it.
Frost precaution
Please take frost protection measures on the dishwasher in winter. Every time
after washing cycles, please operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the
water valve.
3. Drain the water from the inlet pipe and water valve (Use a pan to gather the
water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up
water in the sump.
FR
2.
To remove the lower spray
arm, pull out the spray arm
upward.
NL
PT
3.
Wash the arms in warm
soapy
Water using a soft brush.
Replace them after rinsing
them thoroughly.
EN
133
Publicité
