Intended use
This chain saw may only be used by one person to saw wood. The chain saw must be held with the right hand on the
rear handle and the left hand on the front handle. Before using the chain saw, the user must have read and under-
stood all information and instructions in the operating instructions. The user must wear appropriate personal protective
equipment (PPE).
The chain saw is only permitted to be used to cut wood. Materials such as plastic, stone, metal or wood that
contains foreign matter (such as nails or screws) are not permitted to be cut.
Residual risks
Residual risks remain even if you use this tool as intended. The following hazards can occur due to this tool's con-
struction and design:
1. Lung damage if a suitable dust mask is not worn.
2. Hearing damage if suitable hearing protection is not worn.
3. Cuts if suitable protective clothing is not worn.
4. Damage to health, which results from hand and arm vibrations if the device is used for an extended period or not
operated or maintained properly.
Warning! This machine generates an electromagnetic field when operated. This field can affect active or passive med-
ical implants in certain circumstances. In order to reduce the risk of severe injury or death, we recommend that people
with medical implants consult their doctor or the manufacturer of the medical implant before operating the machine.
Warning!
The prolonged utilisation of a tool will subject the user to vibration and shocks that could lead to Raynaud's syndrome
or Carpal tunnel syndrome.
This condition reduces the ability of the hand to sense and regulate temperature, causes numbness and a sensation
of heat and can lead to damage to the nervous system and the circulatory system and to necrosis.
Not all factors that lead to Raynaud's syndrome are known but cold water, smoking and illnesses that impact the blood
vessels and the circulatory system as well as severe or long-lasting exposure to vibrations are known to be factors in
the development of Raynaud's syndrome.
Observe the following in order to reduce the risk of Raynaud's syndrome and Carpal tunnel syndrome:
• Wear gloves and keep your hands warm.
• Make sure the device is well maintained. A tool with loose components or with damaged or worn-out dampers will have
a disposition towards increased vibrations.
• Always hold the handle firmly but do not clutch it constantly with excessive force. Take breaks often.
All of the above precautions cannot exclude the risk of Raynaud's syndrome or Carpal tunnel syndrome. Therefore,
with long-term or regular use it is advisable to keep a close watch on the condition of your hands and fingers. Seek
medical attention immediately in the event of any of the above symptoms appearing.
General safety instructions
Noise emission information in accordance with
the German Product Safety Act (ProdSG) and
the EC Machine Directive: the noise pressure
level at the place of work can exceed 80 dB(A).
In such cases the operator will require noise pro-
tection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the
local regulations when operating your device.
Read and understand the operating instructions
before using the appliance. Familiarise with the control
elements and how to use the appliance properly. Abide
by all the safety measures stated in the service manual.
Act responsibly toward third parties.
The operator is responsible for accidents or risks to third
parties.
In case of any doubts about connection and operation
refer please to our customer center
GB | Operating Instructions
General Power Tool Safety Warnings
provided with this power tool. Failure to follow all
instructions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
KEEP THESE INSTRUCTIONS CAREFULLY!
1) Work area safety
a) Keep work area clean and well lit. Cluttered or
b) Do not operate power tools in explosive
3
WARNING Read all safety warnings,
instructions, illustrations and specifica tions
dark areas invite accidents.
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.