Standstill And Disposal - Helios Rvmd Serie Notice De Montage Et D'utilisation

Installation and Operating Instructions
m
DANGER
nm
m
WARNING
n
m
CAUTION
n
Round duct shutter motorised – RVMD..
6.2

Standstill and disposal

m
Danger to life due to electric shock!
When dismantling, live parts can be exposed, which can result in electric shock if touched. Before dismant-
ling, isolate the unit from the mains power supply and protect against being switching on again!
All measures may only be carried out by specialists.
m
WARNING!
During dismantling, there is a risk of persons being crushed, grazed or cut between the shutter and the venti-
lation ducts or on the casing. Before dismantling, isolate the unit from the power supply and secure it against
being switched on again! All measures may only be carried out by specialists. Use personal protective equipment.
m
CAUTION!
During dismantling, there is a risk of persons being crushed, pulled in or trapped or fingers being sheared
off due to an unintentional restart. Before dismantling, isolate the unit from the power supply and secure it
against being switched on again! All measures may only be carried out by specialists. Use personal protective
equipment.
Parts and components whose service life has expired, e.g. due to wear and tear, corrosion, mechanical load, fatigue
and/or other effects that cannot be directly discerned, must be disposed of expertly and properly after disassembly
in accordance with the national and international laws and regulations. The same also applies to auxiliary materials in
use. Such as oils and greases or other substances. The intended and unintended further use of worn parts, e.g. impel-
lers, rolling bearings, filters, etc. can result in danger to persons, the environment as well as machines and systems. The
corresponding operator guidelines applicable on-site must be observed and used.
7
EN