CAUTION — If the power cord is damaged, it must be replaced immediately by your
manufacturer, or a qualified dealer, to avoid the risk of electric shock.
CAUTION — Do not damage the refrigeration circuit.
CAUTION — Do not use electrical devices inside the compartment unless permitted by the
manufacturer.
CAUTION — The refrigerant and insulation system contain flammable gases. When disposing
of the device, do so at an authorized collection center. Never expose the device to flames.
Refrigerant
Isobutane refrigerant (R600a) is used in the device's refrigerant circuit. It is a highly flammable
natural gas, and therefore dangerous for the environment. During transport and installation of
the appliance, check that none of the components of the refrigeration circuit are
refrigerant (R600a) is a flammable liquid.
Warning: Risk of fire
If the refrigeration circuit was damaged:
•
Avoid naked flames and all sources of ignition.
•
Ventilate the room where the device is located.
It is dangerous to modify the composition of this device in any way. Any damage to the cord may
cause a short circuit, and/or electric shock.
Electrical Safety
•
We cannot be held responsible for any incident caused by improper electrical
installation.
•
The power cord must not be extended. Do not use an extension cord, adapter or
multiple sockets.
•
Check that the wall socket is not damaged. A wall outlet in poor condition could
cause the device to overheat and explode.
•
Make sure you can access the device's wall socket.
•
Never pull on the main cable.
•
Never remove the ground.
•
If the wall outlet is loose, do not plug in the cord. There is a risk of electric shock or
fire.
•
This appliance operates on single phase current of 220~240V/50Hz. The device
must use a wall outlet connected to the earth
force.
•
If the power cable is damaged, do not replace it but contact your after-sales service.
according to the recommendations in
24
damaged. The